Sale!

labgruppene82labgruppenthisistheperfectmomenttoshopandenjoyhugesavings0.jpg

labgruppene82labgruppenthisistheperfectmomenttoshopandenjoyhugesavings1.jpg

Lab Gruppen E 8:2 Lab Gruppen

$ 324,75

SKU: mode_2443597381 Category: Power Amps Tags: Lab Gruppen, New Gear, Power Amplifiers

Description
shopping

800W Amplifier with 2 Flexible Output-Channels for Installation Applications

E Series E 8:2

The E 8:2 has smart green credentials delivering low lifetime cost of ownership.

Energy Star Qualified

By maintaining very low current draw during operating cycles even at high output levels, and reduced power consumption during non-operational cycles, our Energy Star qualified products harness impeccable Lab Gruppen sonic performance and robust power output while meeting the rigorous efficiency requirements of current Energy Star certification standards.

Small in Size, Huge in Benefits

Building on Lab Gruppen’s touring reputation for sonic excellence and rock-solid durability, E Series brings a competitive edge to the installation market by adding ultra-compact size, high operating efficiency, output configuration flexibility, and an unprecedented cost-benefit ratio.

At the heart of E Series is Lab Gruppen’s IDEEA (IntelliDrive Energy Efficient Amplifier) technology. Based around a patented Class D variant output stage, IDEEA produces high power levels with very low distortion while drawing minimal mains current.

Lab Gruppen’s proprietary Rail Sensing Limiter (RSL), also exclusive to E Series, greatly reduces signal clipping to ensure high quality audio output at all times. User configurable for Hi-Z (70 V) or Lo-Z, RSL senses rail voltages and optimizes each output for instantaneous load conditions. RSL settings also facilitate asymmetric loading of the channels to optimize performance and efficiency. Total available output power can be allocated among the channels as required by the application. This makes it possible, for example, to drive a small sub on one channel, a number of 70 V ceiling loudspeakers on the second channel.

Lab Gruppen Performance with Energy Star Compliance

Lab Gruppen’s IDEEA architecture secures full Energy Star compliance by combining net operating efficiency of greater than 80% with an auto-power-down feature. After 20 minutes with no input signal, the amplifier automatically switches to standby mode – with consumption of less than 1 W – and switches back on when an input signal returns. GPIO facilities enable third-party systems to remotely control and monitor power state via contact closure.

Smart Green Credentials with Our IDEEA Platform

The now proven IntelliDrive Energy Efficient Amplifier (IDEEA) platform represents the latest evolution of our amplifier design philosophies, drawing from technologies in our flagship PLM Series, to create ingenious contractor solutions with supreme green credentials.

Flexible Asymmetric Loading

Optimize performance and efficiency from each individual unit – allowing the total available output power to be utilized unequally between the channels, or for mono use with all power on a single channel. Enabling you to drive a small sub on one channel and a number of 70 V distributed ceiling loudspeakers on the other.

Specification

General

Number of amplifier channels	2
Max total output all channels driven	800 W
Peak output voltage per channel	100 V / 70 Vrms
Max. output current	16 Arms

Max output power (all channels driven)

2 ohms	400 W
4 ohms	400 W
8 ohms	400 W (requires the “70 V” mode for the RSL, “Lo-Z” gives 200 W)
16 ohms	290 W (requires the “70 V” mode for the RSL, “Lo-Z” gives 100 W)
70 V	400 W
100 V	Can deliver 400 W to a 100 V load tapped at 800 W

Performance

THD 20 Hz – 20 kHz at 1 W	<0.1%
THD at 1 kHz and 1 dB below clipping	<0.05%
Signal to Noise Ratio	>112 dBA
Channel separation (Crosstalk) at 1 kHz	>70 dB
Frequency Response	2 Hz – 40 kHz
Input impedance	20 kOhm
Common Mode Rejection (CMR)	50 dB
Output impedance	25 mOhm

Gain, Sensitivity and Limiters

Limit and gain switch defining limit and gain (per channel)	2 pos: Lo-Z and 70 V
VPL for 70 V mode	100 V
VPL for Lo-Z mode	56.6 V
Sensitivity for stated power into 4 Ohm in Lo-Z mode	4 dBu
Sensitivity for 70.7 V out in 70 V mode	4 dBu
Sensitivity for stated power into 2 Ohm in Lo-Z mode	1 dBu
Sensitivity for stated power into 8 Ohm in 70 V mode	2.1 dBu
Sensitivity for stated power into 16 Ohm in 70 V mode	3.7 dBu
Gain in 70 V mode	35.2 dB
Gain in Lo-Z mode	30.3 dB
Level adjustment (per channel)	Rear panel potentiometer, from -inf to 0 dB

Connectors and Buttons

Input connectors (per ch.)	3 – pin detachable screw terminals, electronically balanced
Output connectors (per ch.)	2 – pin detachable screw terminals
High pass filter	Fixed at 50 Hz, switchable per channel
Power control	Can be used to go between standby and ON
GPI (power control input)	Contact closure type, 2-pin detachable screw terminal, controls the power state
GPO (power state output)	Contact closure type, 2-pin detachable screw terminal, for external monitoring of the power state
Cooling	Single fan, front to rear airflow, no filter required, temperature controlled speed

Power

Nominal voltage	100 – 240 VAC
Operating voltage	70 – 265 VAC
Standby consumption	<1 W
Mains connector	IEC inlet

Dimensions

Dimensions

W: 483 mm (19”), H: 44 mm (1 U), D: 276 mm (10.9”)

Weight

Weight

4.2 kg (9.3 lbs)

Finish

Finish

Dark grey aluminum front and black steel chassis

Approvals

Approvals

CE, RoHS, WEEE, UL (UL 60065), CSA C22.2 NO. 60065, FCC Part 15 Subpart B Class A, PSE, CCC Energy Star

Prompt Delivery and Professional Packaging

Our long-standing partnership with UPS FedEx DHL and other global carriers lets us offer a range of shipping services. Our warehouse staff is extremely skilled and will package your items according to our precise and exact specifications. Your goods will undergo an extensive inspection and be safely packaged prior to being sent out. Each day, we ship to thousands of customers in many countries. The fact that we are committed to becoming the biggest online retailer in the World is clear. These warehouses are in Europe in the same way as they are in USA.

Note: Orders that include more than one item are assigned a processing period depending on the item.

Before shipping, we will inspect thoroughly the items you have ordered. Most orders are shipped within 48 hours. Expected delivery time is between 3-7 days.

Returns

Stock is dynamic. It's not entirely managed by us since we are involved with multiple entities, including the factory and the storage. The actual stock can change at any moment. It is possible that your order may be out of stock once the order has been placed.

Our policy lasts for 30 days. We cannot exchange or refund your order if it has been 30 days from the date of purchase.

For your item to be returned it must be in its original packaging, unopened and in the condition you received it. The item must be in its original packaging.